Tuffy Security 189 - Manual

Page 1 of 1 – 09/26/2011 – Rev092611
INSTALLATION INSTRUCTIONS
#189 Flip-Up License Plate Holder
Please read and fill out the enclosed warranty registration card to activate your warranty.
Parts Checklist
#1 Flip-Up License Plate Holder
#189 Shipping Package
#3.2 (2) ¼” Phillips head screws #3.3 (2) ¼” washers #3.4 (2) ¼” Nylon lock nuts
Tools required
•
Snap Ring Pliers
•
#2 Phillips Screwdriver
•
7/16” wrench
ATTENTION:
•
THIS FLIP-UP LICENSE PLATE HOLDER WAS DESIGNED TO
WORK WITH STANDARD ROLLER-STYLE WINCH FAIRLEADS.
Mounting Directions
1. Using appropriate snap ring pliers, remove the (2) #4.2 external snap rings at the top of your roller fairlead (not
included). Install the #1 Flip-Up License Plate Holder onto the roller fairlead vertical pins as illustrated. Re-Install the
(2) #4.2 snap rings. (Figure 1)
2. Install your license plate onto the #1 Flip-Up License Plate Holder and fasten with the supplied #3.2 screws, #3.3
washers, and #3.4 nuts. (Figure 1)
FIGURE 1
Call (970) 564-1762 for Technical Support