TYREDOG TD-1300A-X5 Programming Instructions User Manual

TYREDOG Accessories communication

Advertising
background image

TD-1000A-X / TD1300A-X Learnable Sensor Programming Guide

Replacement LEARNABLE Sensor Part Numbers

Model: SN-1000A-X-FL (Front Left / Wheel 1)

Model: SN-1000A-X-FR (Front Right / Wheel 2)

Model: SN-1000A-X-RL (Rear Left / Wheel 3)

Model: SN-1000A-X-RR (Rear Right / Wheel 4)

Model: SN-1300A-X-5 (Spare Tyre / Wheel 5)

In the event that a sensor is lost, stolen or damaged, it can be replaced with a ‘LEARNABLE Sensor.’ These sensors have
their own special code and can only replace those of the same type and wheel location. For example, if sensor FR is
damaged, it can only be replaced by a ‘FR LEARNABLE Sensor.’ LEARNABLE sensors can be purchased individually at
any authorised Tyredog reseller or online at

www.tyredog.com.au

.


TD-1000A-X Learn Mode

1) Press and Hold the Mute

Button, then Switch the Monitor On

.

(Some earlier models, you will need to Press and Hold the Temperature

Button, then Switch the Monitor On

.

This will activate the LEARNING mode and the LCD Monitor will display ‘LEN’ like shown below.

Note: The unit will remain in LEARNING MODE for 20 seconds before automatically exiting.

2) Once the system is in LEARNING mode you can stop holding the Button down and proceed with programming your

new LEARNABLE sensors. Simply insert the battery into the LEARNABLE sensor and this will program it to the
Monitor. When the code is learnt, the monitor will beep once, and the new code will be displayed in the corresponding
wheel location on the display.

Note: If you attempt to program a NON LEARNABLE SENSOR, the unit will beep 3 times. You can only program
LEARNABLE Sensors.




TD-1300A-X Learn Mode

3) The TD-1300A-X units do not have and ON/OFF Switch. To enter LEARNING mode, you will need to remove the

Batteries from the Monitor (Or DC Power Cord). Once removed, Press and Hold the Light

Button, then either

insert the batteries into the monitor or connect the DC Power Cord and this will activate the LEARNING Mode.

4) Once in LEARNING Mode, refer to Step #2 above.

TD-1000A-X

TD-1300A-X

Enter LEARN mode

Insert Battery

Sensor Programmed

Advertising
This manual is related to the following products: