Cisco 3560 - Manual (Page 15)

1-5
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 1 Product Overview
Front Panel Description
The 10/100 ports on the switch are grouped in pairs. The first member of the pair (port 1) is above the
second member (port 2) on the left, as shown in
Figure 1-4 . Port 3 is above port 4, and so on. The SFP
module slots are numbered 1 to 4.
Figure 1-4 Catalyst 3560-48TS-S and 3560V2-48TS Switch Front Panel
The console port, 10/100 PoE ports, and a dual-purpose port are on the front panel of the Catalyst
3560-8PC switch and the Catalyst 3560-12PC-S switch (
Figure 1-5 and Figure 1-6 ). The dual-purpose
port can use either an RJ-45 connector or an SFP module, but not both at the same time.
For more information on the dual-purpose port, see the “Dual-Purpose Port” section on page 1-10 . For
more information on the console port, see the “Console Port” section on page 1-19 .
Figure 1-5 Catalyst 3560-8PC Switch Front Panel
1 10/100 ports 2 SFP module slots
126807
2
1
Catalyst 3 560 SERIES
SYST
RPS
STAT
DUPLX
SPEED
MODE
1 2 5 6 7 8 9 10 11 12 13 14 15 16
3 4 1X
2X
15X
16X
17 18 21 22 23 24 25 26 27 28 29 30 31 32
19 20 17X
18X
31X
32X
33 34 37 38 39 40 41 42 43 44 45 46 47 48
35 36 33X
34X
47X
48X
1
2
3
4
1 Console port 3 Dual-purpose port
2 10/100 PoE ports
2 3
Catalyst 2960 S eries
CONSOLE 1x
SPD
DPLX
STAT
SYST
MODE
2x 3x 4x 5x 6x 7x 8x
1
1
157822