Mounting the switch on a wall – Cisco 3560 User Manual
Page 46
2-14
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 2 Switch Installation (24- and 48-Port Switches)
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in
See the
“Wall-Mounting” section on page 2-12
for the switches that can also mount with the front panel
facing down.
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Figure 2-12
Mounting the Switch on a Wall
After the switch is mounted in the rack:
1.
Power on the switch. See the
“Verifying Switch Operation” section on page 2-6
.
2.
Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the Catalyst 3560 Switch
Getting Started Guide for instructions. To use the CLI setup program, see
“Configuring the Switch with the CLI-Based Setup Program.”
3.
Connect to the front-panel ports.
1
User-supplied screws
97927
Cat
aly
st
37
50
SE
RIE
S
13
X
14
X
SY
ST
RP
S
MA
ST
R
ST
AT
DU
PL
X
SP
EE
D
ST
AC
K
MO
DE
2X
2X
2X
1
1