Clarion XAZ611 - Manual (Page 11)

XAZ611
15
English
Tape Operations
APC (Auto Program Control) function
The APC function allows the tape to skip forward
to the beginning of the next track or rewind to the
start of the current track.
● Skipping forward to the next track (“APC-
FF”)
During tape playback, press the right side of
SEARCH button
% twice to fast-forward to the
next track. The next track starts playing.
● Skipping backwards to the start of the cur-
rent track (“APC-REW”)
During tape playback, press the left side of
SEARCH button
% twice to rewind to the start
of the current track. The current track plays from
the beginning.
● Canceling FF/REW APC to resume playback
Press Play/pause button # .
∗
If you select another mode during APC mode, it is
selected with APC mode continued.
The mechanism automatically makes APC mode
stop when it finds the next track (in APC-FF) or
the start of the current track (in APC-REW). This
function is called “monitor mode”.
Dolby noise reduction system
The Dolby noise reduction system increases the
volume level of high frequency sounds during
recording and sets it back to their original level
during play. This system reduces hissing noise
which is typical of cassette tapes.
∗
Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
1. Press DOLBY NR button 6 to select Dolby
noise reduction. Each time you press DOLBY
NR button
6 , the Dolby changes in the fol-
lowing order:
DOLBY B NR ON
➜ DOLBY NR OFF ➜ DOLBY
B NR ON....
2. When DOLBY B NR ON is selected, “DOLBY
B NR” appears in the display.
Intro tape scan
The intro tape scan allows the first 10 seconds
of all the tracks on the tape to be played.
This function continues automatically until it is
canceled.
1. Press SCN button
4 to start the intro tape
scan. “SCN” lights in the display.
2. To cancel the intro tape scan, press SCN but-
ton 4 again. “SCN” goes off from the display
and the current track continues to play.
∗
When the end of the tape is reached during the
intro tape scan, the tape mechanism automatically
reverses direction and continues the intro tape
scan.
∗
If you select another mode during the intro tape
scan, the mechanism automatically makes the intro
tape scan stop when it finds the next track (APC
function).
Tape selection repeat
The tape selection repeat continuously plays the
current track. This function continues automatically
until it is canceled.
1. Press RPT button
5 . “RPT” lights in the dis-
play and the current track is repeated.
2. To cancel the repeat play, press RPT button
5 again. “RPT” goes off from the display and
normal play resumes.
Blank tape skip
The blank tape skip allows you to skip blank sec-
tions of tape that are over 12 seconds long.
1. Press and hold RPT button
5 for 1 second
or longer. “BLS” lights in the display and the
mechanism fastforward to the next track se-
lection.
2. To cancel the blank tape skip, press and hold
RPT button 5 for 1 second or longer again.
“BLS” goes off from the display and normal
play resumes.
Notes:
The APC, intro tape scan, tape selection repeat and
blank skip may not work properly with tapes of the
following qualities:
• Tapes on which the recording level is too low.
• Tapes on which there is much noise between se-
lections.
• Tapes on which there are long pauses in the middle
of selections.
• Tapes on which there are less than 4 seconds of
blank space between selections.