Cisco 1-PORT G.SHDSL 2600 - Manual (Page 19)

1-Port G.SHDSL WAN Interface Card for Cisco 2600 Series Routers
dsl operating-mode (G.SHDSL)
19
Cisco IOS Release 12.2(4)XL
dsl operating-mode (G.SHDSL)
To specify an operating mode of the digital subscriber line for an ATM interface, use the
dsl operating-mode ATM interface command. To restore the default operating mode, use the no form
of this command.
dsl operating-mode gshdsl symmetric annex {A | B}
no dsl operating-mode
Syntax Description
Defaults The default operating mode is gshdsl symmetric annex A.
Command Modes ATM interface
Command History
Usage Guidelines This configuration command applies to a specific ATM interface. You must specify the ATM interface
before you enter this command.
The ATM interface must be in the shutdown state before you enter this command.
gshdsl Configures the DSL ATM interface to operate in multirate high-speed mode
per ITU G.991.2.
symmetric Configures the DSL ATM interface to operate in symmetrical mode per ITU
G.991.2.
annex{A | B} Specifies the regional operating parameters. Enter A for North America and
B for Europe. The default is A.
A Configures the regional operating parameters for North America. This value
is the default.
B Configures the regional operating parameters for Europe.
Release Modification
12.1(3)XJ This command was introduced on the Cisco 1700 series routers.
12.2(2)T This command was integrated into Cisco IOS Release 12.2(2)T for the
Cisco 1700 series routers.
12.2(4)XL This command was integrated into Cisco IOS Release 12.2(4)XL for the
G.SHDSL WIC on the Cisco 2600 series routers.