One-piece doors – Craftsman 1/2 HP GARAGE DOOR OPENER MODEL 139.5364812 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ONE-PIECE DOORS

Please read and comply with the warnings and
reinforcement instructions on the previous page.

They apply to one-piece doors also.

• Center the door bracket on the top of the door, in

line with the header bracket as shown. Mark either

the left and right, or the top and bottom holes.

• Drill 5/16" pilot holes and fasten the bracket with

hardware supplied.

If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag

screws (not provided) to the top of the door.

NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16”x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.

24

Advertising