Hamilton Beach 395W - Manual (Page 2)

IMPOFTTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be observed, including the following:
1. Read all instructions.
2. To protect against risk of electrical shock, do not immerse Motor
Base in water or other liquid.
3. Unplug cord from outlet when not in use, before putting on or
taking off parts, and before cleaning.
4. Avoid contacting moving parts. Keep fingers out of Food Chute.
5. Always make sure Juice Extractor Cover is clamped securely in
place before motor is turned on. Do not unfasten Cover Latches
while juicer is in operation.
6. Never operate without Pulp Bin in place.
7. Be sure to turn switch to Off position after each use of your Juice
Extractor. Make sure the motor stops completely before
disassembling.
8. Do not put fingers or other objects into the Juice Extractor Food
Chute while it is in operation. Never feed food by hand - always
use Food Pusher. If food becomes lodged in opening, use Food
Pusher to push it down. When this method is not possible, turn
the motor off and disassemble juicer to remove the remaining
food.
9. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions, or is dropped or damaged in
any manner. Return appliance to Hamilton Beach/Proctor Silex,
Inc. or to the nearest authorized service facility for examination,
repair or adjustment.
10. The use of attachments not recommended or sold by Hamilton
Beach/Proctor-Silex, Inc. may cause fire, electric shock, or.injury.
11. Do not use outdoors.
12. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
13. Do not leave Juice Extractor unattended while it is operating.
14. Blades are sharp; handle carefully.
SAVE THESE INSTRUCTIONS
DISASSEMBLY AND ASSEMBLY OF JUICE EXTRACTOR
1. Unplug cord from outlet.
2. Unlatch Cover Latches by pulling up on the bottom of the latch.
3. Lift the Cover and remove the Cutter/Strainer, rinse parts under
running water to remove food.
4. Remove the Pulp Bin and juice container. Empty and rinse under
running water.
5. To reassemble, replace Pulp Bin on Motor Base.
6. Place Cutter/Strainer in Pulp Bin on drive gear. Position cover in
place and fasten cover latches. Slide juice container into place.
Never Operate Without Pulp Bin In Place.
HOW TO USE
1. Wash fruits and vegetables thoroughly. Remove pits, stones and
large seeds from apricots, cherries, peaches, plums, etc. Peel thick
skinned fruits and vegetables - oranges, lemons, tangerines,
watermelons, pineapples,'cucumbers, squash; etc.
2. Cut food into pieces to fit the Food Chute. ■
3. Plug cord into 120 volt AC outlet.
4. Be sure Juice Container is in place.
5. Press switch on.
6. Place food in Food Chute and press lightly with Food Pusher. Never
Use Fingers as a Food Pusher. Food should be placed in Food
Chute Only when unit is operating. Food can be continuously placed
in Food Chute without having to turn unit off.
7. The capacity of the Pulp Bin is 2 pounds. To empty, repeat process
in “Disassembly and Assembly of Juicer Extractor”.
8. When juicing is completed, press or turn Switch Off to stop unit.
Unplug the cord from the outlet.
9. Always use the speeds recommended in the Extraction Yields Chart.
Note: Various fruit and vegetable juices can be made without having
to clean the unit as flavors will not mix.
HOW TO CARE FOR YOUR JUICE EXTRACTOR
After use,, unplug Juice Extractor. Promptly disassemble Juice Extractor
and wash each part in hot sudsy water. Rinse Cutter/Strainer from
under side for easy removal of residue from strainer holes. It may be
necessary to use a brush. Never use a metal brush on cutter teeth or
strainer holes. (Dishwasher cleaning is not recommended.) Never
immerse Motor Base in water. Use a soft, damp cloth to wipe the motor
base. Some foods, such as carrots and beets, may stain plastic parts.
Remove stains with baking soda. Rinse stained parts in water, make a
paste of baking soda and water, rub on stained area with a soft damp
cloth or sponge. Rinse and dry. After washing, dry all the parts,
reassemble and store.