Cisco Cisco Unified Communications Server 2000.4.3a - Manual (Page 29)

29
Installing the Operating System on the Cisco Unified Communications Server, Versions 2000.4.3 and 2000.4.3a
OL-10221-02
Error Messages
The memory detected was not a minimum
expected <number> MB
Actual detected memory: <number> MB
Please correct before reattempting installation.
Memory Size Fatal Error
This message displays when the server does not
have the minimum memory. Before you proceed
with the installation, increase the memory.
The number of CPUs detected was not the
expected <number> count
Actual detected CPU count: <number>
Please correct before reattempting installation.
CPU Count Fatal Error
This message displays when the server does not
have the correct number of processors. Before you
proceed with the installation, correct the problem.
The CPU speed detected was not the expected
<number> MHz.
Actual detected CPU speed: <number> MHz
Please correct before reattempting installation.
CPU Speed Fatal Error
This message displays when the server processors
do not have the correct CPU speed. Before you
proceed with the installation, correct the problem.
The hard drive size detected was not the expected
<number> MB
Actual detected size: <number> MB
Please correct before reattempting installation
Drive Size Fatal Error
This message displays when the size of the
physical drives is not the correct value. Before you
proceed with the installation, install hard drives
that meet the minimum requirements.
The number of hard drives detected was not the
expected <number> drive(s)
Actual detected number: <number>
Please correct before reattempting installation.
Drive Size Fatal Error
This message displays when the number of
physical drives is not the correct value. Before you
proceed with the installation, inspect the drives
and correct the number of drives, if required.
Configuring the RAID Array Controller.
System will reboot upon completion...
Configuring RAID Controller
The system automatically configures the RAID
Array Controller and reboots. You do not need to
take any action.
The BIOS Version detected is prior to the
approved version of: <number>
Actual detected version: <number>
Please correct before reattempting installation
BIOS Version Fatal Error
The installation may not support the system BIOS
family. This message may display if the server is
not supported. Before you proceed with the
installation, correct the problem.
Table 6 Error Messages (continued)
Error Message Corrective Action