Programming, Program mode, Entering program mode – Chauvet Obey 40 User Manual

Page 21: Exiting program mode, I. programming lights, Rogramming

Advertising
background image

Obey™ 40 User Manual Rev. 7

Page 21 of 160

4.

P

ROGRAMMING

Program Mode

Program mode is used to program for playback. In Program mode lighting looks are created and
saved for playback. There are three parts to programming for playback.
1. Programming lights: selecting and controlling them to create looks.
2. Programming scenes: saving the looks into scenes.
3. Programming chases: saving the scenes into chases.
The next section describes how to program lights, scenes, and chases, and how to modifying and
delete scenes and chases.

Lights can be programmed in Playback mode, but the looks created in Playback mode
cannot be saved.

Entering Program

Mode

To enter Program mode do the following:
1. Turn the board on.
2. Press and hold <Program> for three seconds.
3. The program indicator light, in the lower left corner of the LCD Display, comes on.
4. Release <Program>.

Exiting Program

Mode

To exit Program mode, do the following:
1. Press and hold <Program> for three seconds.
2. The program indicator light, in the lower left corner of the LCD Display, goes out and the blackout

indicator light goes on.

3. Release <Program>.

Blackout activates whenever the board exits Program mode. Blackout must be deactivated
to see the lighting looks. See

<Blackout>

for more information.

I. Programming

Lights

Programming lights is controlling them with the faders to set colors, positions, and operating modes.
The result of controlling lights is a look.
Programming lights in Program mode and creating looks is the first part of programming for
playback.
Playback is when the programmed looks are played back for a show. The looks are played back
from scenes and chases. See

5. Playback

for more information. Lights can be controlled in Playback

mode, but looks created in Playback mode cannot be saved.

· Refer to the light’s user manual for information about the light’s DMX channel

assignments. User Manuals for CHAUVET® products are on the Chauvet website at

http://www.chauvetlighting.com/product-manuals-literature/

.

· Programming for playback can only be done in Program mode.
· Fixture buttons are inclusive. More than one light can be selected at a time. Pay attention

to the fixture button LEDs because they indicate which lights are selected.

· Two fixtures can be programmed at the same time, but they should have the same or

DMX channel assignments.

· The instructions below use specific lights, scenes, banks, and chases, but the operations

can be performed on any light, scene, bank, or chase.


Advertising