Britax ADVOCATE - Manual (Page 20)

35
ADVOCATE User Guide
34
BRITAX Child Safety, Inc.
Incompatible Vehicle Seat Belts
The following types of vehicle seat belts are NOT
compatible with this child seat. If any of the belt types
listed below are in the chosen seating position, choose
another vehicle seating position or check your vehicle
owner’s manual for information on installing a car seat in
your vehicle.
Care and Maintenance
Seat Cover
Removing the Cover
Never remove the buckle tongues from the harness.
They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
1. Loosen and unbuckle the
harness.
a. Lift harness adjuster
lever.
b. Pull both harness
straps forward.
c. Unbuckle the
harness.
2. Open the chest clip.
a. Press tabs
b. Pull apart
3. Remove the infant
positioning pillow if
necessary.
4. Remove the belly pad and
buckle.
a. Lift the cover from
the seat to find
the buckle strap
connection.
b. Remove the buckle
strap by turning
the buckle retainer
sideways and
routing it out of the
front buckle slot in
the child seat (see
page 38).
c. Slide the end of the
belly pad over the
foam pad on the
seat.
Lap-shoulder belts
with top or bottom
anchor points on
the vehicle door�
Motorized,
automatic vehicle
seat belts�
Lap-shoulder
belts that have a
separate retractor
each for the
lap section and
shoulder section�
Lap belts forward
of the vehicle seat
bight�
Lap belts with a
sewn-in latch plate
that have a retractor
that locks only in
case of a sudden
stop�
4c
4b
4a
a
b
c. Tightens by feeding
the belt webbing
back into the
retractor.
2. Locking Latch Plate
a. Has a latch plate
that prevents the
webbing from
becoming loose.
NOTE: Ensure the latch
plate and vehicle belt
lie flat against the child
seat or the vehicle belt
may remain unlocked.
b. Tightens by pulling
on the belt webbing.
Latch plate
Adjuster
1b
1a