NETGEAR N600 Wireless Dual Band Gigabit Router WNDR3700v3 - Manual (Page 23)

Configuring Your Wireless Network 19
Configuring Your Wireless Network
After installing your router, you must log into the router to complete your wireless setup. When
you log in to the browser, you will be prompted to check for firmware updates from the
NETGEAR update server.
Accessing Your Router After Installation and
Checking for New Firmware
The Smart Wizard only appears when you run the CD. If you want to change the settings after
installing and configuring your router, you can click the desktop shortcut—a pre-configured
shortcut
placed on your desktop by the Smart Wizard at installation—to open the router
management interface. 1 You can also change your settings, or configure your wireless and security
settings, by opening a browser window and logging in to the router. You will also be prompted to
check for new router firmware for the router.
To log in to the router after installation:
1. Open a browser window and type http://www.routerlogin.net in the address field of your
browser. Press Enter.
2. When prompted, enter the Password ( admin is the default router User Name and password is
the default router Password), both in lowercase letters. If you changed the Password from the
defaults, then enter your new Password.
1. The shortcut icon is installed on your desktop only when using the Smart Wizard installation method.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
The router User Name and Password are unique to the router and are not the
same as any other User Name or Password you may use to log in to your
Internet connection.