Garmin Edge 800 - Manual (Page 19)

Edge 800 Owner’s Manual 15
ANT+ Sensors
About the gSC 10
Cadence data from the GSC 10 is
always recorded. If there is no GSC 10
paired, GPS data is used to calculate
the speed and distance.
Cadence is your rate of pedaling or
“spinning” measured by the number of
revolutions of the crank arm per minute
(rpm). There are two sensors on the
GSC 10: one for cadence and one for
speed.
For information about cadence alerts,
see page 5 .
Non-Zero Averaging for
Cadence Data
The non-zero data-averaging setting
is available if you are training with an
optional cadence sensor. The default
setting is to exclude zero values that
occur when you are not pedaling.
To turn the non-zero averaging on
or off, select MENU > > Bike
Settings > Data Recording > Data
Averaging > Cadence.
Third-Party ANT+ Sensors
For a list of third-party ANT+ sensors
that are compatible with the Edge, go
to www.garmin.com/intosports .
Pairing Your Power Meter
Refer to the manufacturer’s
instructions.
When the power meter is paired, a
message appears, and appears
solid on the status page.
Calibrating Your Power Meter
For calibration instructions specific
to your power meter, refer to the
manufacturer’s instructions.
Before you can calibrate your power
meter, it must be properly installed and
actively recording data.