Moving the printer, Before moving the printer, Moving the printer to another location – Lexmark E260dn User Manual

Page 91

Advertising
background image

6

Install the unit into the printer by aligning the arrows on the guides of the unit with the arrows in the printer. Push
the unit fully in.

7

After replacing the photoconductor kit, reset the photoconductor counter:

Open the front door and then press and hold

until all the lights cycle.

Warning—Potential Damage: Resetting the photoconductor counter without replacing the photoconductor kit
may damage your printer and void your warranty.

8

Close the front door.

Moving the printer

Before moving the printer

CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or
printer damage:

Turn the printer off using the power switch, and then unplug the power cord from the wall outlet.

Disconnect all cords and cables from the printer before moving it.

Lift the printer off the optional drawer, and set it aside instead of trying to lift the drawer and printer at the same
time.

Note: Use the handholds located on both sides of the printer to lift it off the optional drawer.

Use only the power cord provided with this product or the manufacturer's authorized replacement.

Warning—Potential Damage: Damage to the printer caused by improper moving is not covered by the printer warranty.

Moving the printer to another location

The printer and options can be safely moved to another location by following these precautions:

Any cart used to move the printer must have a surface able to support the full footprint of the printer. Any cart
used to move the options must have a surface able to support the dimensions of the options.

Keep the printer in an upright position.

Avoid severe jarring movements.

Maintaining the printer

91

Advertising
This manual is related to the following products: