Hunter XC - Manual (Page 14)

11
ENG
Manually Run All Stations
ALL
1. Turn dial to manual – all
sTaTIons position.
2. Select program A, B, or C by
pressing the button.
3. Station run time will flash in the display. Use the or
button to select the amount of time for a station to water
if different from the run time displayed.
4. Use the button to move to the next station.
5. Repeat steps 3 and 4 to customize each station.
6. Press the button until you reach the station at which you
would like watering to begin.
Turn the dial clockwise to the run position (the controller will
water the entire program beginning with the station number
last left in the display, then return to the automatic mode with
no change in the previously set program).
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can
select program B or C by pressing the button.
3. The station number will be flashing. Press the button to
scroll through the stations and use the or button to
adjust station run times. (If no buttons are pressed for a
few seconds during step 2 or 3, the controller will auto-
matically begin watering).
4. Press the button scroll to the station you wish to begin
with. After a 2 second pause, the program will begin. At
any time during the manual cycle, you can use the or
buttons to navigate from station to station manually.
Seasonal Adjustment
Seasonal Adjust is used to make global
run time changes without re-program-
ming the entire controller. To use the
seasonal adjustment feature:
1. Turn the dial to the seasonal
adJusTmenT position.
2. The display will now show a flashing number followed by
a %, as well as the bar graph which always remains on the
display. Press the or button to adjust the percentage
of the seasonal adjustment. Each bar on the graph
represents 10%. This feature can adjust the controller from
10% to 150% of the original program.
To view the adjusted run times, simply turn the dial to the
run TImes position, the displayed run time will be updated
accordingly as the seasonal adjustment is made.
NOTE: The controller should always be initially
programmed in the 100% position.
Manually Run a Single Station
1
1. Turn dial to manual – one
sTaTIon position.
2. Station run time will flash in the
display. Use the button to move to the desired station.
You may use the or button to select the amount of
time for a station to water.
3. Turn the dial clockwise to the run position to run the
station (only the designated station will water, then the
controller will return to automatic mode with no change
to the previously set program). Also see one Touch start
and advance.
programmIng THe ConTroller
MANUAL-ONE STATION 1
MANUAL-ALL STATIONS ALL SEASONAL ADJUSTMENT