Maintenance and cleaning, Warning indicator, Maintenance & cleaning – Canon LV-S4 User Manual

Page 45

Advertising
background image

45

The WARNING indicator shows the state of the function which protects the projector. Check the state of the WARNING
indicator and the POWER indicator to take proper maintenance.

VOL

-

WARNING

LAMP REPLACE

POWER

WARNING
blink red

TOP CONTROL

Warning Indicator

The projector is shut down and the WARNING indicator is blinking red.

When the temperature inside the projector exceeds the normal
temperature, the projector is automatically shut down to protect
the inside of the projector. The POWER indicator is blinking and
the projector is being cooled down. When the temperature inside
the projector returns to normal, the POWER indicator emits red
light and the projector can be turned on.

Note:

• After the temperature inside the projector returns to normal, the WARNING

indicator still continues to blink. When the projector is turned on again, the
WARNING indicator stops blinking.

Then check the matters below:

– Did you provide appropriate space for the projector to be

ventilated? Check the installing condition to see if ventilation
slots are not blocked.

– Is the projector not installed near the ventilation duct of air-

conditioning equipment which may be hot? Install the
projector away from the ventilation duct of air-conditioning
equipment.

– Are the air filters clean? Clean the air filters periodically. (p46)

VOL

-

WARNING

LAMP REPLACE

POWER

WARNING
emit red light

TOP CONTROL

The projector is shut down and the WARNING indicator emits red light.

When the projector detects an abnormal condition, it is
automatically shut down to protect the inside and the WARNING
indicator emits red light. In this case, disconnect the AC power
cord and reconnect it, and then turn the projector on once again
for check. If the projector is still turned off and the WARNING
indicator emits red light, disconnect the AC power cord and
contact the service station for check and repair.

CAUTION

DO NOT LEAVE THE PROJECTOR WITH THE AC
POWER CORD CONNECTED UNDER THE ABNORMAL
CONDITION. IT MAY RESULT IN FIRE OR ELECTRIC
SHOCK.

Maintenance and Cleaning

Maintenance & Cleaning

Advertising