Mv801 • mv802 commands, M^sql ^^802 – AstroStart MV-801/802 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
M^SQl ^^802
MV801 • MV802 COMMANDS
COMMAND
BUTTONS
ACKNOWLEDGE
Start/stop
A
Lights, 1
Lock /Unlock
B
Lights, 1 / 2
Sentinel
A&B
Lights, 4/ 2/3
START COMMANDS
S
tart
/S
top
The Start-Stop command is in fact the reason for being of your remote starter.
It allows you to start or stop your vehicle without stepping outdoors.
•
Press the "A" button once
U
pon
starting
The parking lights will flash once to confirm the reception of the command,
then will stay ON as long as the engine will be running under remote control
(10 or 20 minutes according to programming ).
I
f
engine
fails
to
start
If your system cannot start your engine at first attempt, it will wait for a few
seconds and then try again (it could try again twice depending on reason for
failure to start), after which it will shut down automatically and wait for new
command.
U
pon
stopping
The engine and parking lights will turn off.
The command is only applicable when engine is running under remote
control.
U
pon
entering
your
vehicle
...
•
Do not apply the brakes upon entering your vehicle (which would stop the
engine).
•
Place the key in the ignition switch and turn it to the "RUN" position.
DO NOT TURN THE KEY TO THE "START" POSITION
A
• Drive as usual.