Black & Decker 3803-10 - Manual

MAINTENANCE (Unplug Chain Saw)
1. Keep chain sharp and tensioned correctly.
2. Turn bar over periodically (5 hours use) to ensure even wear on topand bottom rails.
3. Clean accumulated sawdust and oil from passages at the base of the bar, to ensure
proper lubrication of chain and bar groove.
4. Do not use fluids or cleaning agents to clean the saw. Excessive moisture can cause
a short-circuit. Strong cleaning agents and solvents such as kerosene and gasoline
can attach the plastic housings. Wipe the saw clean with rags and use a small brush
to clean the motor cooling air inlet and exhaust slots,
5. The chain saw uses self-lubricating bearings and relubrication is not required.
However, after two seasons of use we recommend a thorough cleaning and
inspection at a Black & Decker Service Center.
6. If the Chain Saw fails to operate, disconnect extension cord from power source first,^
and then from the chain saw. Check service panel for blown fuse or tripped circuit
breaker and examine the extension cord for damage. If chain saw still will not operate,
do not attempt to repair it yourself, take it to a Black & Decker Service Center
for repair.
ACCESSORIES
Use of other than specified accessories may be hazardous.
Model 3801-10
1 4 "
3802-10
16"
3803-10
Guide Bar 38000 38001 38002
Saw Chain 38003 38004 38005
File 38006 38006 38006
File Guide 38007 38007 38007
IMPORTANT
To ensure product safety and reliability, repairs, maintenance and adjustment (other
than those described in the mianual) should be performed by B & D Authorized Service
Centers or other qualified service organizations. Always use B & D replacement parts.
Note: Use only the correct length of bar and chain types as replacements (See
nameplate). An increase in length may overload and damage the motor.
COMMERCIAL/INDUSTRIAL USE WARRANTY
Black & Decker warrants this product for one year from date of purchase. We will repair
without charge, any defects due to faulty material or workmanship. Please return the
complete unit, transportation prepaid, to any Black & Decker Service Center or
Authorized Service Station listed under ‘Tools Electric" in the yellow pages. This
warranty does not apply to accessories or damage caused where repairs have been
made or attemped by others.
MOTOR
Your Black and Decker tool is powered by a B&D-built motor. Be sure your power supply
agrees with nameplate marking.
Volts 50/60 Hz means Aiternatiiig Cyrrentiy ONLY, Volts
DC“60 Hi means it will also operate on Direet Current, Voltage decrease of more than 10%
will cause loss of power and over-heating. All B&D tools are factory-tested; if this tool does not
operate, check the power supply,
DO NOT CONNECT TOOL TO DC POWER SUPPLY
Form No. 237595
BLACK & DECKER (U.S.) INC.
INDUSTRIAL/CONSTRUCTION DIVISION
626 HANOVER PIKE, HAMPSTEAD, MD 21074 U.S.A,
Eieistrie ©ihiiiic Sm:
Model 3801-10 - 12" Electric Chain Saw
Model 3802-10 - 14" Electric Chain Saw
Model 3803-10 - 16" Electric Chain Saw
IMPORTANT
BEFORE YOU PLUG IN YOUR BLACK & BECKER ELECTRIC CHAIN S A W . . .
© Read Owner’s Manual
© Check chain for proper tension
© Ensure chain brake lever is pulled back fully
(Motor will not run if brake engaged.)
Black & Decker Electric Chain Saws are Double-Insulated for added protec­
tion against electric shock. This also eliminates the need for a 3 prong
grounding plug.
omima