Alvin Armrest CH25A - Manual

Assembly Instructions for
Armrest No. CH25A
PARTS LIST
KEY QTY DESCRIPTION
1 2 P.U. ARMREST
2 2 ARM PLATE (PRE-ASSEMBLED TO KEY 1)
3 1 SUPPORTING BAR
4 2 LOCK WASHER
5 2 FLAT WASHER
6 2 ADJUSTMENT KNOB
7 4 M6x26mm MACHINE SCREW
INSTRUCTIONS :
STEP 1
USE (7) SCREWS TO FIX THE (3) SUPPORTING BAR TO YOUR CHAIR MECHANISM
AS DRAWN BELOW.
STEP 2
INSERT (2) ARM PLATE INTO (3) SUPPORTING BAR. ALIGN THE PRE-DRILLED
HOLES OF (2) ARM PLATE AND (3) SUPPORTING BAR AND THEN INSERT THE (6)
ADJUSTMENT KNOB WITH (4) LOCK WASHERS (5) FLAT WASHER UPWARD INTO
THE HOLE OF (3) SUPPORTING BAR AND TIGHTEN KNOBS FIRMLY.
WARNING!
USE THIS PRODUCT FOR SEATING ONLY ONE PERSON AT A TIME. DON’T
USE AS A STEP LADDER.
DO NOT USE THIS CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE
SECURELY TIGHTENED.
AT LEAST EVERY SIX MONTHS, CHECK ALL BOLTS, SCREWS AND KNOBS TO BE
SURE THEY ARE SECURELY TIGHTENED.
IF ANY COMPONENT IS MISSING, DAMAGED OR WORN, STOP USE OF THE
PRODUCT UNTIL REPAIRS CAN BE MADE.CONTACT FOR FACTORY AUTHORIZED
REPAIR PARTS. FAILURE TO FOLLOW THESE WARNINGS MAY RESULT TO
SERIOUS INJURY.