Autostart AS-6205i SH - Manual

Diagnostics - Parking Lights Fiash Rate
Flashes Description
1
• Doors locked, Starter Kill armed.
• End of Run Time.
• TRUNK button pressed
• START signal received by the Module.
• Cold Weather Mode cancelled.
• Cannot start after maximum number of attempts Is reached.
2
• Run Time cancelled
• Remote start attempt cancelled by remote
• Doors unlocked, Starter Kill disarmed.
• Exiting remote valet
• Exiting Ignition Valet
3
• Entering Cold Weather Mode
•
Entering remote valet
• Entering Ignition valet
• Extended runtime
4
• +12 volts detected on the Brake line; cranking cancelled
• Entering Tach Learning
5
• New Transmitter learnt
• Tach learnt
6
• Remote start attempt was made with a Tach or a vacuum signal detected before
cranking
8 • Unit reset: occurs when the unit Is reset to factory defaults
10 • The Hood Switch line went to ground during cranking or run time
1 - pause -
2
• There was an attempt to start the vehicle while the Module was In Valet Mode.
2 - pause -
2
• There was an attempt to start the vehicle while the Module was In Home Valet
Mode.
ON solid • Cold Weather Mode: the Brake Pedal Is being held down
ON 2 sec.
• The Hood Is up and the Hood Switch line went to ground. This Is step one of the
Programming Mode
ON 3 sec.
• First press of the START button under Safe Start.
• Entering Home Valet Mode
ON 4 sec. • LOCK or UNLOCK pulse (If door pulse Is configured to 4 sec.)
ON 25 sec.
• If the Hood PIn-swItch has been pressed twice: the Unit went Into step 1 of the
Programming cycle and no Transmitter activity was detected for 20 seconds
• Or the Unit went Into step 1 of the Transmitter Code Learning procedure and no
activity was detected for a few seconds. The Unit has exited the Transmitter Code
Learning procedure.
Irregular
• If the Module gives Irregular flashes (1 to 10 flashes followed by a pause, followed
by more flashes), It Is In Playback Mode. This occurs when the Hood-switch line Is
flashed 3 times.
Constant
flashes
up to 30 sec.
• Panic Mode set off.
P.20 Installation Guide AS-6205Í SH
A U T O M A T I C T R A N S M I S S I O N R E M O T E S T A R T E R
S Y S T E M
AS-6205Ì SH
Instaiiation Guide
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an automatic Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
H.310 S.3.20 DOC: 1.00 CA - October 10, 2006 Manufactured In Canada by Autostart