Denso BHT-6000 - Manual (Page 63)

48
[4.6] Setting the communications environments
After the BHT-6000 is initialized, the interface port and communications parameters
are set as listed in the default table below. Do not access them unless necessary.
Interface port
Communications protocol
Communications parameters
for the optical interface port
TRANSMIT SPEED 9600 bps
PULSE WIDTH 1.63 µs
(Output pulse width of IR beam)
PROTOCOL
(Protocol options)
OPT (Optical interface port)
BHT-protocol
Defaults
SERIAL No. ON: Adds serial numbers to
data blocks.
H. PARITY ON: Adds a horizontal parity.
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore
Listed below are the default communications parameters for the direct-connect inter-
face
Defaults Communications parameters for
the direct-connect interface port
TRANSMIT SPEED 19200 bps
PARITY BIT None
DATA BIT 8 bits
(Character length)
STOP BIT 1 bit
PROTOCOL
(Protocol options) SERIAL No. ON: Adds serial numbers to
data blocks.
H. PARITY ON: Adds a horizontal parity.
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore