Denso BHT-6000 - Manual (Page 64)

49
Chapter 2. Getting Started the BHT-6000 and System Mode
Selecting the "6: COM" on the SET SYSTEM menu
calls up the screen shown at left.
1 OPTICAL: Switches to the communi-
cations parameters setting
screen
for the optical inter-
face .
2 CONNECTOR: Switches to the communi-
cations parameters setting
screen
for the direct-con-
nect interface.
3 COM PORT: Switches to the interface
port setting screen.
4 PROTOCOL TYPE: Switches to the communi-
cations protocol type set-
ting screen.
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET SYSTEM menu, press the C
key.
SET COM
1:OPTICAL
2:CONNECTOR
3:COM PORT
4:PROTOCOL TYPE
[4.6-1] Setting the communications parameters for the optical interface
SET OPTICAL
1:TRANSMIT SPEED
2:PULSE WIDTH
3:PROTOCOL
Selecting "1:OPTICAL" on the SET COM menu calls
up the screen shown at left.
1 TRANSMIT SPEED: Switches to the transmis-
sion speed screen.
2 PULSE WIDTH: Switches to the IR beam
output pulse width
screen.
3 PROTOCOL: Switches to the commu-
nications protocol option
menu.
Select a desired screen by using the numerical
keys or F5 and F6 keys, and then press the ENT
key.
To return to the SET COM menu, press the C key.