Denso BHT-6000 - Manual (Page 78)

63
Chapter 2. Getting Started the BHT-6000 and System Mode
[5.5] Communications test
In System Mode, you may test the optical interface port and direct-connect interface
port.
■ Preparation for the optical interface test
Arrange two BHT-6000s, one as a master station and the other as a slave station (to be
tested) with their IR ports facing each other as illustrated below. In this test, the slave
BHT-6000 transmits data to the master BHT-6000 and receives the data sent back from
the master BHT-6000.
Master BHT-6000 Slave BHT-6000
(to be tested)
Data
0.8 m
■ Preparation for the direct-connect interface test
Arrange the 3-pole mini stereo plug as illustrated below and connect it to the direct-
connect interface port on the BHT-6000.
SD
RD
Selecting the "5:COMMUNICATION" on the TEST
menu calls up the screen shown at left.
1 OPTICAL : Switches to the MASTER/
SLAVE selection screen for
the optical interface test.
2 CONNECTOR : Tests the direct-connect inter-
face port.
TEST COM
1:OPTICAL
2:CONNECTOR