Dimplex Electric Fireplace DF1136L - Manual (Page 7)

7
Quick Reference guide
before using the fireplace 1.
verify:
Are the circuit breakers •
for the unit on?
Are the light bulbs •
loose? (To check, follow
the instructions for
replacing the light bulbs
under the maintenance
section of this manual)
If you have any technical 2.
questions or concerns
regarding the operation
of your electric fireplace,
or require service contact
customer service.
The heater may emit a slight,
3.
harmless odor when first
used. This odor is a normal
condition caused by the initial
heating of internal heater
parts.
Site Selection
The unit is packaged with two
types of mounting options:
Wall mounting, surface •
Pedestal •
!
NOTE: A 15 Amp, 120
volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or the
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
Fireplace Installation
WARNINg: Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric