Advanced Control Technologies Specs Instructions ZRW100I (RF 120 VAC, 15A, Feed ThroughWall Switch, Ivory) - Manual

ZRW100 Instructions
110503
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0618-01
1
Radio Frequency Controlled, 120 VAC,
Wall Mounted Switch
ZRW100
HomePro
RF Home Automation
Shown with user supplied
Decora TM trim plate
ZRW100 WALL MOUNTED SWITCH
The ZRW100 Wall Mounted Switch is a component of the HomePro lighting control system. Wire the Wall Mounted
Switch in place of the standard wall switch according to the diagram above and program from the Wireless Controller
to operate loads. Inclusion of this Wall Mounted Switch on the ZTH100 Wireless Controller menu allows remote ON/
OFF control of lamps connected.
This Wall Mounted Switch is designed to work with other HomePro lamp and appliance controls. Z-Wave nodes of
other types can be added to the system and will also act as repeaters if they support this function of repeating the signal
received to other modules in the system.
As part of a HomePro network, the ZRW100 will also act as a wireless repeater to insure that commands intended
for another device in the network are received. This is useful when the device would otherwise be out of the radio
range of the wireless controller.
There are no field repairable assemblies on this unit. It is covered by a one year limited warranty. If service is needed,
the unit must be returned where purchased.
CAUTION! Read and understand these instructions before installing. This device is entended for installation in
accordance with the National Electric code and local regulations in the United States, or the Canadian Electrical Code
and local regulations in Canada. It is recommended that a qualified electrician perform this installation.
Make sure the load controlled the switch does not exceed 1800 watts. For indoor use only. Retain instructions for
future use.
INSTALLATION
Wire this Wall Mounted Switch in place of a current wall switch according to the diagram above. See the ZTH100
Wireless Controller operating instructions to add this module under the command of the Wireless Controller.
Wall Mounted Switch Configuration
The Wall Mounted Switch locally controls the load ON and OFF. A push on the top or bottom of the paddle switch
is used to configure the module to operate from the wireless controller. With the Wireless Controller, the Wall
Mounted Switch can be switched ON and OFF remotely, and can be included in groups of lights that operate at
the same time (a group can also be a single module), and in scenes that set a lighting mood.
Switch power ON and OFF locally
When the top of the paddle is pressed, the power will turn on. When the bottom of the paddle is pressed, the power
will turn off.