Alwarerc Cyclone X8 Octocopter Super Combo - Manual (Page 7)

4 Assembly Steps – Motor and ESC
1.) Prepare your motors. 2.) For the new motors, Thread Lock
must be applied to the two M3 Set
Screws which is pre-installed. 3.) Install the Porp Mount to the motor
using 3pcs M3x8mm Hex Cap Screw. 4.) Solder two pair Power/ESC Board
Power Cable to your Battery Connectors.
5.) Solder the other Ends to the
Power/ ESC Board which is pre-
installed inside the Main Frame
Body.
6.) Parallel two ESCs. 7.) Solder Black and Red AWG wires
to 2pcs of ESCs in Parallel. Same for
other 3 pairs of ESCs.
8.) Solder 4 pairs AWG wires to the
POWER/ ESC Board inside the
Main Frame Body of Cyclone X8.
7