Bullard CC20E - Manual

Bullard’s CC20E Series airline respirators, when properly used,
provide a continuous flow of air from a remote air source to the
respirator wearer. CC20E Series respirators offer protection from
airborne contaminants that are not immediately dangerous to life or
health or that do not exceed concentrations allowed by applicable
regulations and recommendations. If you have any questions con-
cerning the use of this respirator, or if you are not sure whether the
atmosphere you are working in is immediately dangerous to your
life or health, ask your employer. All instructions for the use and
care of this product should be supplied to you by your employer as
recommended by the manufacturer.
CC20E Series airline respirators are approved to provide respirato-
ry protection in general purpose applications including pharmaceuti-
cal manufacturing, chemical and pesticide handling, spray painting,
or other industrial applications. The 20TICE model is intended for
general use applications, and the 20TICHE model is used in work
environments that require head protection. The 20SICE model
includes a long outer bib and taped seams for protection from liquid
penetration.
This respirator, when properly fitted and used, significantly reduces,
but does not completely eliminate, the breathing of contaminants by
the respirator wearer. When properly fitted, used, and maintained,
it will provide protection up to 1000x occupational exposure limit.
(Check regulatory requirements to determine exposure limits.)
Improper respirator use may damage health and/or cause death.
Improper use may also cause certain life-threatening delayed lung
diseases such as silicosis or pneumoconiosis. This respirator is not suitable for use in flammable atmospheres and
is not designed for use in exceptionally low or high temperatures
where moisture in the air could freeze or the worker could be at
risk for heat exhaustion. The air supply moisture content should
be controlled to avoid freezing the apparatus when used at
temperatures below 4°C.
Face and Eyes
The lens of the 20TICHE model provides protection consistent with
the requirements of EN166 (low energy impact). Wear appropriate
safety glasses or goggles if higher protection levels are required.
Head
The TICH hood, when used with a Bullard model 5100E or 5100RE
hard hat meets EN397 requirements for protective headwear.
These hard hats are designed to provide limited head protection by
reducing the force of falling objects striking the top of the helmet.
Tyvek®
There are uses, environments, and chemicals for which this gar-
ment is not suitable. It is the user’s responsibility to determine
that this garment is appropriate for the intended use. This material
should not be used around heat, open flames, sparks, or in any
potentially flammable or explosive environment. This material is
not flame resistant nor flame retardant and will melt. It can create
static electricity. Contact your employer or Du Pont
® Corporation
at 1-800-44-TYVEK or 00352 3666 5664 for more information on
this material.
Table of Contents
Read all instructions and warnings before using this respirator. Save this manual for future reference.
Warning
CC20E Series airline respirator
User Manual
General Information ............................................................1
Component Concept ..............................................................2
Operations
Breathing Air Pressure Table ...............................................3
Typical Breathing Air Source
and Respirator Configurations .............................................3
Respirator Assembly .........................................................4, 5
Respirator Use ......................................................................6
Inspection, Cleaning, and Storage .......................................7
Parts and Accessories for
CC20E Series Airline Respirators .........................................8
0194
En 270