Clay Paky POINT / POINT IN - Manual

A. Microswitches from 1 to 11: For DMX address setting and programming.
B. Microswitch 12: To select operating mode:
The ON setting enables SLAVE mode.
The OFF setting enables MASTER mode.
C. Led "DMX" (green): When on, it indicates that a DMX input signal
is present and that the starting address is
valid.
When flashing, it indicates that no DMX input
signal is present or that the starting address is
not valid.
D. Led "OUT" (yellow): When on, it indicates that the projector is in
Master mode and can control other projectors.
E. "DMX" address: This is the sum of values corresponding to the
microswitches set to ON.
12V 50W
®
POINT / POINT IN
The projector may be programmed to operate in AUTOMATIC mode (it carries out previously set scenes or sequences), or controlled by a CONTROL UNIT.
E
A B C D
1
1 2 3 4 5 6 7 8 9 10 11 12
ON
2 4 8 16 32 64 128 256
OUT DMX
AUTOMATIC MODE
In automatic, the projector may be configured in two different modes: SLAVE and
MASTER
1) SLAVE Mode: (microswitch 12 set to ON) The projector receives a DMX signal and
carries out the sequences transmitted from a main projector configured in MASTER
mode.
The projectors should have address 1 (see programming automatic SLAVE mode).
OPERATION WITH CONTROL UNIT (DMX mode)
All the projectors must be configured in SLAVE mode (Microswitch 12 set to ON); the
projector receives a DMX signal and carries out the controls transmitted from the
control unit.
2) MASTER Mode: (microswitch 12 set to OFF) The projector generates a DMX signal
that can pilot other projectors in SLAVE mode.
In this case, there should be no DMX signal.
Address: 1
Mode: SLAVE
Max
100
Address: 1
Mode: SLAVE Address: 1
Mode: SLAVE Mode:
MASTER
DMX
Address: 1
Mode: SLAVE
Max
100
Address: 1
Mode: SLAVE Address: 1
Mode: SLAVE Mode:
MASTER
DMX
Address: 1
Mode: DMX Address: 3
Mode: DMX Address: 5
Mode: DMX
Control unit
DMX
On each projector, set the address for DMX digital signal: addresses are valid from 1 to
511 (see Programming operation with Control unit).
Each projector uses 2 control channels.
CHANNEL FUNCTION
1 COLOUR DISC
2 DIMMER
1
1 2 3 4 5 6 7 8 9 10 11 12
ON
2 4 8 16 32 64 128 256
1
2
1
1 2 3 4 5 6 7 8 9 10 11 12
ON
2 4 8 16 32 64 128 256
N.B.: To access the microswitches, remove the electronic card cover.
POINT
POINT IN
MICROSWITCHES
INSTRUCTIONS MANUAL GB
OPERATION
Channel functions and options