Eurocom P180HM Leopard 2.0 - Manual (Page 103)

BIOS Utilities
Advanced Menu 5 - 9
5
Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
You can adjust the Bluetooth module power setting to your preference. The default
setting (Disabled) will see the Bluetooth module powered off when the system is
started up or restarted. Enabling the power setting will have the module retain the
last power status (on or off) before any restart or shut down.
SATA Mode (Advanced Menu)
You can configure SATA (Serial ATA) control to operate in either AHCI (Ad-
vanced Host Controller Interface) or RAID (Redundant Array of Independent
Disks) modes from this menu. The SATA mode should be set BEFORE installing
an operating system, and after you have backed up all necessary files and data (see
sidebar). See
“Setting Up SATA RAID Mode” on page 7 - 2 for details if you are
configuring you hard disks in a RAID.
Legacy USB Support: (Advanced Menu)
Choose “Enabled” if you intend to use USB devices in systems which do not nor-
mally support USB functionality (e.g. DOS). The default setting is “Enabled” and
does not need to be changed if you intend to use your USB devices in Windows.
Boot Logo: (Advanced Menu)
Use this menu item to enable/disable the Boot Logo screen at system startup.

SATA Mode
Selection
Set the SATA mode BE-
FORE installing your
Windows 7 operating
system. Do not change
the mode unless you in-
tend to reinstall your op-
erating system, and
make sure you back up
all necessary files and
data before doing so.