Home Easy HE403 User Manual

He-403 remote control outdoor pir

Advertising
background image

RE-INVENTING THE HOME

HOME

easy

HE-403 Remote control

Outdoor PIR

V1.0

Installation:

The HE-403 Outdoor PIR adds extra security and ease of
use to your Home Easy products

-Selectable timer setting
-10Metre Detection Range
-IP44 Weather Proof
-25 Metre Wire Free Range
-Battery Powered 3*AAA

The HE-403 allows you to control your Home EasyReceiver sockets or modules
via a wire free remote control PIR sensor. When the PIR beam is broken the
outdoor PIR will switch on your Remote control sockets for between 15
seconds and
4 Minutes. Ideal for controlling out door lighting, staircase lighting and house
hold lighting for added security.

1. Fist select your required location, it's recommended that the PIR is installed
approximately 3 metres off the ground (ideally under the eaves of the building)
and, away from direct sources of sunlight or heat.

Warning: Avoid installing the Remote Control PIR onto metallic surfaces
and above heating vents as this will affect the operating performance.

2. Remove the PIR unit from the base and Using the mounting bracket as a
template mark and drill appropriate holes and fix the bracket securely using
the appropriate screws and wall plugs (included).

1. Unclip the battery cover from the bottom of the
PIR using a small screw driver.

Changing Batteries:

2. Remove the batteries and replace using 3
new 'AAA' batteries, making sure the polarity
is correct.

Always dispose of old batteries in an
environmentally responsible way

3. Replace the battery cover making sure the rubber seal is correctly
aligned and firmly push the case together.

Rubber seal

Avoid Direct Heat

Sources

Detection Distance

Advertising