Hope Tech Headset Pre 07 - Manual

Headset
Fitting Cups
Firstly, ensure both ends of head tube are parallel and of correct size. If necessary ream the bore
and face each end of the head tube.
Chamfer the inside edges of the head tube at both ends.
Press in both cups using a headset press fitted with Hope adaptors. Use the hope logo to ensure
the cups are fitted in the correct end of the head tube.
Fitting base plate
Slide the base pate onto the steerer tube with the flat side to the bottom.
Using a suitable tube over the steerer set the base plate into position.
Cutting Steerer
Fit forks into frame. Slide complete top assembly and stem over steerer.
Scribe a line flush with the top of the stem.
Remove stem and cut stem 3mm below the line.
Remove all sharp edges.
With 8mm allen key, adjust Head Doctor until a slide fit inside stem and insert it 10mm into steerer.
Tighten until solid in steerer.
Final Assembly
Liberally apply a good quality waterproof grease to all bearing and sealing surfaces. When fitting
ensure all “o” rings are located correctly.
Insert forks into frame.
Fit top bearing cap, taper ring and sealing cover over steerer.
Fit stem and top cap. Tighten bolt in top cap until forks rotate smoothly without play or restriction.
Hope Technology Hope Mill Skipton Road Barnolodswick BB18 6EN UK
www.hopetech.com Tel:(+44) 01282 851200 Fax:(+44) 01282 851201