Livorsi Plantinum Series - Manual

Livorsi Marine, Inc. Platinum Series Installation Instructions Rev C 1 of 6
715 Center Street Grayslake IL 60030
P: 847-752-2700
F: 847-752-2415
Thank you for choosing Livorsi Marine ® controls. Your new marine engine controls feature a
one year warranty and are built using aluminum and stainless steel to insure years of trouble
free service.
The included 4 O-rings, and 4 stainless steel wood screws MUST be used to install the control
or it will void the warranty. Do not over tighten. Its best to use grease in screw holes to pre-
vent breaking chrome finish.
To install your controls the following tools are needed:
* Phillips screwdriver * 7/16" wrench or socket * 3/16" Allen wrench
Cutouts are available at the end of this packet.
Adjusting detent and friction:
Adjust detent and friction to desired tension by turning allen screw at base of handle.
Place throttle arm and/or detent in the
slightly forward position. Using a 3/16”
allen wrench, reach through the black
rubber to the 3/16” set screw. Tighten or
loosen as needed.
Periodic lubrication of rubber boots in
needed. Teflon base lubricant works best.
Plantinum Series Control Installation Instructions
Standard, Billet and Arched handles