Mighty Mule FM130 - Manual (Page 7)

Wireless Vehicle Sensor rev. 02-18-12 5
POWER
AUX
OUT
SOLAR
INPUT
18VAC/
RCVR
GRN BLK RED EXIT
SAFETY
EDGE CY
CLE
COMMON
LINK
H L
H L
+ –
ON
ALARM ACCESSORY RCVR
SEQ1
SEQ2
LEARN
BLU ORG WHT GRN R B G
CH 1 (Green Wire to Grn)
CH 1 (Blue Wire to Wht)
CH 2 (Yellow Wire to Blu)
CH 2 (Brown Wire to Grn)
RECEIVER
COM COM
CY
CLE
CL
OSE
SAFETY EXIT/ OPEN SHADOW LOOP CL
OSE
EDGE OPEN EDGE
BLK GRN RED
STALL FORCE
MI
N
M
AX
Gate Opener Battery
RED WIRE to POSITIVE
BLACK WIRE to NEGATIVE
RED
BLACK
CH 1 (Green Wire to Com )
CH 1 (Blue Wire to Cycle)
CH 2 (Yellow Wire to Exit)
CH 2 (Brown Wire to Com)
RED to + or H
BLACK to Com
CH 1 (Green Wire to Com )
CH 1 (Blue Wire to Cycle)
CH 2 (Yellow Wire to Exit)
CH 2 (Brown Wire to Com)
Gate Opener Battery
RED WIRE to POSITIVE
BLACK WIRE to NEGATIVE
RED
BLACK
GREEN Control Boards
Step 5: Connect the Receiver’s Channel 2 wires (YELLOW and BROWN) to your control board (see
illustration above). Have someone install the 2 “AA” batteries in the Transmitter Module: this will immediately
start 30 seconds of transmission from the Wireless Vehicle Sensor. During transmission, you will press and
hold the Receiver’s LEARN CH 2 button. The indicator light on the Receiver should blink twice within 1–2
seconds to indicate that the Wireless Vehicle Sensor setting is now programmed into the Receiver.
Step 6: Return to #4: “Test Your System” (page 3).