MTI Wireless Edge MT-120032 - Manual

Antenna Base Lock
Elevation Adjustment Bolt 5/16
Hex Nut 5/16 UNC
Tilt Antenna Plate Assy
Central Bolts
(2 PL)
Hex Nut 5/16 UNC
Azimuth Adjustment Bolt 5/16
Bolt 5/16"x1-3/8" UNC
Spring Washer 5/16"
Flat Washer 5/16"
6 PL.
Azimuth Lock Bolts
(4 PL.)
1
4
3
Grease
Grease
Grease Surface Around
the Slot from Both Sides
Mounting Lock Bolt
5/16"x6.5" UNC
4 PL.
Pin
Dish direction
Dish Antenna Base
Tilt Antenna Plate Assy
Holder Bracket (2 PL.)
Hex Nut 5/16" UNC
Spring Wahser 5/16"
Flat Washer 5/16"
4 PL.
5
6
Mast 2"-4.5" outer diameter
Grease
Hex Nut 5/16" UNC
Spring Wahser 5/16"
Flat Washer 5/16"
2 PL.
Elevation Lock Bolt
5/16"x2" UNC
2 PL.
Joint Lock Bolt
Hex Head Screw
5/16"x5/8" UNC
DETAIL A
SCALE 1 : 1.5
2
Joint Lock Bolt must be fastened
only when the Dish Antenna Base
is in 0 deg Position
Step:4
RD43101200C/D INSTALLATION INSTRUCTIONS FOR MOUNTING KIT
Notes:
- Center the Azimuth Lock Bolts in slot (4 PL.)
- Use tightening torque of 4 Nm on Central Bolts (2 PL).
- Tool required 1/2" open end or deep socket wrench.
- Use grease in marked recomended places.
Step: 1 Step: 2
Notes:
- Roughly aim the Mounting Kit Pin perpendicular
to Dish direction
- Use tightening torque of 9 Nm on Nut
of Mounting Lock Bolt (4 PL).
- Tool required 1/2" open end or deep socket wrench.
- Use grease in marked recomended places.
Notes:
- At any time , keep
Elevation Adjustment Bolt in parallel to the pole.
- Adjustment Bolts must be greased at all time.
- After fine adjustment use tightening torque of 4 Nm on Azimuth
Lock Bolts (4PL) and 9 Nm on Nut of Elevation Lock Bolts (2PL).
- Tool required 1/2" open end or deep socket wrench.
Step:3
7
8
D
C
B
A
A
B
C
D
1 2 3 4 5 6 7 8
8 7 6 5
4 3
2 1
SHEET 1 OF 1