PRW 32 PQ Series Alloy Steel Mopar Shaft Mount Rocker - Manual

PRW Industries, Inc.
1722 Illinois Avenue
Perris, California 92571
Tele: (951) 436-7900
Tech: (888) 377-9779
Installation Instructions For PRW Stainless
Steel Mopar Rocker Arms
PARTS LIST
Item Quantity
Rocker Arms 16 each
Hardened Shafts 2 each
Cup End Adjusters 16 each
Hold Down Studs Big Block: 6 Short, 4 Long 10 each
Hold Down Studs Small Block: 10 Short 10 each
Thin Spacers 16 each
Thick Spacers 8 each
Shim Kit 48 pcs
Large Hold Downs 4 each
Small Hold Downs 6 each
Extreme Pressure Lube #3 1 1/4oz tube
Quick Tips
1. All pushrods in a set do not wear evenly or uniformly. Over time each will wear in a unique fashion as it
“mates” with the individual rocker arm that it is paired with. Consequently, old pushrods should be replaced
when new rocker arms are installed.
2. Make sure rocker arms and other components are well lubricated. Proper lubrication of all parts can help
prevent premature wear and/or permanent damage.
3. Check for any interference between rockers and valve covers.
4. Always use hardened shafts. Stock or unhardened shafts will result in premature wear and rocker arm
failure.
5. Make sure oil holes on shafts are facing down.
Installation
Step 1
After removing the rockers and other components from the package thoroughly wash each piece, and then
blow dry.
Step 2
Totally submerge the rockers in engine oil for approximately 30 minutes prior to installation to insure the
needle bearings are lubricated.