PRW 33 PQ Series Aluminum Mopar Shaft Mount Rocker User Manual

Parts list item quantity

Advertising
background image

PRW Industries, Inc.

1722 Illinois Avenue

Perris, California 92571

Tele: (951) 436-7900

Tech: (888) 377-9779

Installation instructions for prw aluminum

mopar rocker arms

PARTS LIST

Item

Quantity

Aluminum Rocker Arms

16 each

Hardened Shafts

2 each

Ball End Adusters

16 each

Long Hold Down Bolts

4 each

Short Hold Down Bolts

6 each

Thin Spacers

16 each

Thick Spacers

8 each

Shim Kit

48 pcs

Large Hold Down Spacers

4 each

Small Hold Down Spacers

6 each

Extreme Pressure Lube #3

1 ¼ oz tube


NOTE: PRW Aluminum Mopar Rocker Arm part numbers 0331801, 0331802, 0331803, 0331804,
0344001, 0344002, 0344003, 0344011, 0344012, and 0344013 are designed exclusively for 5/16” ball
end adjusters and cup end pushrods.


Quick Tips

1. All pushrods in a set do not wear evenly or uniformly. Over time each will wear in a unique

fashion as it “mates” with the individual rocker arm that it is paired with. Consequently, old
pushrods should be replaced when new rocker arms are installed.

2. Make sure rocker arms and other components are well lubricated. Proper lubrication of all parts

can help prevent premature wear and/or permanent damage.

3. Check for any interference between rockers and valve covers.
4. Always use hardened shafts. Stock or unhardened shafts will result in premature wear and rocker

arm failure.

5. Make sure oil holes on shafts are facing down.


Installation

Step 1
After removing the rockers and other components from the package thoroughly wash each piece, and then
blow dry.

Step 2
Totally submerge the rockers in engine oil for approximately 30 minutes prior to installation to insure the
needle bearings are lubricated.

Advertising