SkyRC 14S 10A BEC User Manual

Instruction manual, 14s 10a output, Introduction

Advertising
background image

Low Voltage Alarm LED

Power on LED

3mm Hole for Fixing

INSTRUCTION
MANUAL

Congratulations on your purchase of the SkyRC’s SUPER BEC

. This new Battery Eliminator Circuit is

using synchronous rectification method to withstand high current loads of 10Amps continuous integrated with a low
voltage monitor. It provides safe and consistent power to your R/C receiver and servo(s) that eliminates the need for a
separate battery source.

(SK-600053)

LiPo batteries are unlike other batteries and discharges on a non-linear curve, therefore it is important not to drain any
LiPo batteries to minimum before charging as it can cause permanent damage. The SkyRC BEC can prevent this by
giving you an indication of your LiPo battery when the pre-set low voltage level is reached . The SkyRC SUPER BEC
is ideal for today's more demanding R/C aircrafts equipped with servos that require even higher current demands.
Please read the entire manual before proceeding.

INTRODUCTION

Output -

Output +

Connect to Battery

Connect to Pin-Flag

Power Switch

Model: SK-600053

www

.skyrc.com

INPUT

S

SW

AUX

S

ON

OFF

OUT

1

2

3

4

ON

Low Voltage
Alarm-ADJ

Voltage DIP Switch
Alarm Switch

Pin-Flag Power Switch

MOVE BEFORE FLIGHT

YELLOW

WHITE

RED

BLACK

14S 10A OUTPUT

FEATURES

Compact high efficiency 5.2V 6.0V 6.8V 7.4V 8.4V selectable voltage regulator and low voltage monitor.
Ideal for 3-14 cell lithium polymer battery applications. Input voltage range from 10V Min to 60V Max.
High current capability of 10 Amps continuous, 15 Amp peak.
Protects against thermal and current overload(internal RED LED blinking).
Pin-Flag power switch with ultra bright super flux LED allows you to turn the BEC output power on or off
remotely and gives low voltage warning.

TOP VIEW

BOTTOM VIEW

PIN-FLAG POWER SWITCH

Input:

LiPo

3-14S

Output: 5.2-8.4V

10A

SUPER BEC

7.4V
6.8V
6.0V
5.2V

Input Voltage: 11.1-60V(3-14 LiPo Cells)
Output Voltage: 5.2V-8.4V Selectable
Low Battery Alarm Voltage: 10V-60V

SUPER BEC

(Synchronous Rectification)

Low Voltage
Alarm-ADJ

Fine

-ADJ

SUPER BEC

(Synchronous Rectification)

RE

Advertising
Table of contents