Star Headlight & Lantern SP3860-4 Switch Panel - Manual

PLITSTR142 REV. C 12/23/04
WIRING INSTRUCTIONS FOR STAR SWITCH #SP3860-4
(ON/OFF)(ON/OFF)(ON/OFF)(ON/OFF) Switches
1. IMPORTANT: Please read all of the following instructions before installing your
new switch. This instruction sheet applies only to the model #SP3860-4. The
#SP3860-4 is designed to operate four warning lights or strobe packs.
2. CAUTION: All of our DC powered warning lights are polarity sensitive. These
lights are polarity protected only if the appropriate fuses are used. All wires
connected to the positi ve terminal of the battery should be fused at the battery for
their rated load, in addition to the fuse provided at the switch panel. Testing the
light before these fuses are properly installed will void the warranty on the
switch and light.
3. The black wire from terminal 3 of Switch 1 is the ground lead and should be
connected to a good chassis ground.
4. The black wires from all four warning lights should be connected to good
chassis grounds.
5. Connect the red wire from terminal 2 of Switch 1 to the red wire from one of your
warning lights.
6. Connect the blue wire from terminal 2 of Switch 2 to the red wire from the
second warning light.
7. The orange wire from terminal 2 of Switch 3 should be connected to the red wire
from your third warning light.
8. The green wire from terminal 2 of Switch 4 should be connected to the red wire
from your fourth warning light.
9. Connect the fused red wires from terminal 1 of Switch 1 and from terminal 1 of
Switch 3 to the positive side of the 12VDC power through a 10, 15, or 20 amp
fuse, depending upon the total current draw of the lights you are installing. Be
sure to check the label on the warning lights for proper voltage and current.
10. When properly installed, Switch 1 will be on the left side of the switch panel
(front view) and turn your first strobe light on and off, Switch 2 will be second
from the left and turn the second warning light on and off, Switch 3 will be third
from the left on the switch panel and turn the third warning light on and off, a nd
Switch 4 will be on the right and turn your fourth warning light on and off.
If you have any questions concerning this or any other Star product, please contact
our Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please contact our Customer Service
Department at 585-226-9787 to obtain a Returned Goods Authorization number (RGA
#) before you ship the product back. Please write the RGA # clearly on the package
near the mailing label.
The SP3860-4 is designed to operate four warning lights or
strobe packs. Please refer to the diagram on the reverse side of
this sheet and the written instructions below for proper wiring.
SP3860-4 SWITCH PANEL (REAR VIEW)
SW4
OFF
ON
BLACK RED
GOOD
CHASSIS
GROUND
GREEN
WARNING LIGHT
#4
OFF OFF OFF
CONNECT TO +12 VDC
ORANGE
SW3
10 AMP FUSE
BLUE
SW2 SW1
RED
ON
3 3
1
2
1
2
3
1
2
ON
3
2
1
ON
GOOD
CHASSIS
GROUND
WARNING LIGHT
#3
BLACK RED
GOOD
CHASSIS
GROUND
WARNING LIGHT
#2
BLACK RED
GOOD
CHASSIS
GROUND
WARNING LIGHT
#1
RED BLACK
BLACK
10 AMP FUSE
CONNECT TO
+12 VDC
GOOD
CHASSIS
GROUND
ONE YEAR LIMITED WARRANTY
The manufacturer warrants each new product, under normal use, against factory defects
in material and workmanship for one year after the date of purchase. The owner will be
responsible for returning to the Service Center any defective item(s) with the
transportation costs prepaid. The manufacturer will, without charge, repair or replace
at its option, products, or part(s), which its inspection determines to be defective.
Repaired or replacement item(s) will be returned to the purchaser with transportation
costs prepaid from the service point. A copy of the purchaser's receipt must be returned
with the defective item(s) in order to qualify for the warranty coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes,
and/or the finish. This warranty shall not apply to any light, which has been altered,
such that in the manufacturer's judgment, the performance or reliability has been
affected, or if any damage has resulted from abnormal use or service. This warranty does
not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse,
lightning, power surges, or failure to follow instructions in any enclosed manuals. Any
damage or defects occurring as a result of any unauthorized service or repairs by
unauthorized persons shall be excluded from this warranty.
There are no warranties expressed or implied (including any warranty of merchantability
or fitness), which extend this warranty period. The loss of use of the product, loss of
time, inconvenience, commercial loss or consequential damages, including
costs of any labor, are not covered. The manufacturer reserves the right to change
the design of the product without assuming any obligation to modify any product
previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights
which may vary from state to state. Some states do not allow limitations on how long
an implied warranty lasts. Some states do not allow the exclusion or limitation of
incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s)
may not apply to you.