Star Headlight & Lantern TCS-1 Traffic Control Device - Manual

PLITSTR262 REV. A 8/19/09
TCS-1 and TCS-2
STOP/STOP and STOP/SLOW Signs
Use of the Traffic Control Sign
With the batteries properly inserted and the cap in its tightened position, the product will
automatically turn on when the unit is held upright. A position sensing switch automatically
turns the unit on in the upright position and off when the unit is held downward. This
prevents the lights from operating when they are not needed and also conserves the
battery power.
To completely shut off the power, unscrew the cap at the end of the handle 1 turn. This
should always be done when the unit is in storage or during transportation to prevent
accidental activation of the lights that would drain the batteries unnecessarily. During
normal use, the position switch will power the unit on and off.
All operators using the Traffic Control Sign product should be trained in traffic control by
their local authorities. When stopping of traffic is desired, raise the device to overhead and
the lights will come on automatically. The STOP surfaces must be facing the oncoming
traffic. Make certain that all traffic is completely stopped before proceeding into the road.
Keep the device upright during the entire traffic stopping operation. When the task is
completed, exit the road area and then lower the device, the lights will automatically turn
off.
Care of the Traffic Control Sign
Do not use harsh chemicals or abrasives to clean the product. A cloth, slightly dampened
with water, may be used to clean the outside of the product. Do not apply any unnecessary
force or abrasion to the lights. This product is designed for use in any weather condition;
however, reasonable care should be exercised in preventing undue damage to the unit.
Battery replacement
Replace the batteries when the lights fail to flash or flash erratically.
Depending on actual use conditions, the batteries will power the unit for 60 plus hours
running continuously (non stop with no intermittent off periods). If the device is used in an
intermittent condition, the total battery life will be extended.
1. Three alkaline “C” cell batteries are required to power the device.
2. Remove the cap at the end of the handle and insert the three “C” cell batteries with the
positive terminal (small round tip) going into the handle first.
3. After all three batteries are inserted, replace the cap and turn it all the way to a slight
snug stop position.
4. The cap also acts as the Master Switch for the product. By unscrewing the cap 1 turn;
all power to the unit will be switc hed off. This should only be done during
transportation of the sign or when the work with the sign is completed.
TCS-6
6ft Extension Post for TCS-1 and TCS-2 sign
1. Activate the master switch at base of the handle by turning the cap clockwise until snug.
2. The lights will activate when the sign is held upright.
3. Hold the extension post at approximately 45 degrees and slide the handle of the
activated sign into the open slotted end of the post. Rotate the sign in the post until it
slides into the slots in the end of the post.
4. The post is held vertical and rotated so that the desired side is facing the proper traffic
lane STOP or SLOW.
5. To temporarily discontinue traffic control, simply rotate the post and sign so that the sign
is parallel to traffic (No surfaces are visible to oncoming traffic).
If you have any questions concerning this or any other product,
please contact our Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please contact our Customer Service
Department to obtain a Returned Goods Authorization Number (RGA #) before you ship the
product back. Please write the RGA # clearly on the package near the mailing label.
This control s ign is designed to alert drivers more effectively than
conventional signs and flags, especially in inclement weather conditions or
at night time. However, proper traffic control procedures must always be
followed. Only trained traffic control operators should use this product.
Notice: The Traffic Control Sign cannot stop an oncoming vehicle that is
traveling too fast, did not see the sign, or is disregarding the traffic
control sign and operator. Proper training must be provided by your
local agency before using this product. Do not stare directly into the
lights while operating the Traffic Control Sign.
ONE YEAR LIMITED WARRANTY
The manufacturer warrants each new product, under normal use, against factory defects in material
and workmanship for one year after the date of purchase. The owner will be responsible for
returning to the Service Center any defective item(s) with the transportation costs prepaid. The
manufacturer will, without charge, repair or replace at its option, products, or part(s), which its
inspection determines to be defective. Repaired or replacement item(s) will be returned to the
purchaser with transportation costs prepaid from the service point. A copy of the purchaser's
receipt must be returned with the defective item(s) in order to qualify for the warranty coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the
finish. This warranty shall not apply to any light, which has been altered, such that in the
manufacturer's judgment, the performance or reliability has been affected, or if any damage has
resulted from abnormal use or service. This warranty does not apply to defect or damage occurring
as a result of disaster, accident, abuse, misuse, lightning, power surges, or failure to follow
instructions in any enclosed manuals. Any damage or defects occurring as a result of any
unauthorized service or repairs by unauthorized persons shall be excluded from this warranty.
There are no warranties expressed or implied (including any warranty of merchantability or fitness),
which extend this warranty period. The loss of use of the product, loss of time, inconvenience,
commercial loss or consequential damages, including costs of any labor, are not covered.
The manufacturer reserves the right to change the design of the product without assuming any
obligation to modify any product previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights which may vary
from state to state. Some states do not allow limitations on how long an implied warranty lasts.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
Therefore, the above limitation(s) or exclusion(s) may not apply to y ou.