StorCase Technology 9-Bay 4U SCSI Ultra160 - Manual (Page 6)

InfoStation Installation Guide - Rev. C01 StorCase Technology, Inc.
Installation 1
INFOSTATION INSTALLATION
CAUTION: The InfoStation contains NO USER SERVICEABLE PARTS inside the unit.
Warranty is VOID if any of the modules inside the InfoStation are opened.
Refer ALL servicing to qualified service personnel!
Danger of explosion if the battery is incorrectly replaced! Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer'sinstructions.
WARNING: Before adding or removing DRAM modules, disconnect the battery pack
from the battery back-up module.
Installing the Drive(s) into the InfoStation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive(s) being installed. Also refer to the manufacturer's documentation provided with
the drive(s).
A #2 Phillips screwdriver will be required.
Drive Preparation
1. Remove the drive from its protective packaging.
2. SCSI Drive Termination - Disable SCSI termination from the drive. Refer to the
documentation provided by the drive manufacturer for the location of these terminators
or jumpers.
Refer to section "Termination of the SCSI Bus at the VHDCI Connectors" in the
InfoStation User's Guide for further information.