Taser Axon-Body User Manual

Taser axon body quick start guide, Step 2: camera operation led, Operating mode operation led

Advertising
background image

Step 2:

Camera Operation LED

The AXON body camera’s operation LED displays the system’s current operating

mode.

Operating Mode

Operation LED

Recording

Blinking red

Buffering

Blinking green

Booting up/powering down

Solid red

Step 3:

Battery LED

The camera’s battery LED displays the battery’s remaining capacity, when the device

is being used or when charging.

Battery Status

Battery LED

Battery capacity is 41–100%

Green

Battery capacity is 20–40%

Yellow

Battery capacity is less than 20%

Red during operation; flashing red and

yellow during charging

Battery critically low

Blinking red and yellow

TASER AXON body Quick Start Guide

English (U.S./Canada/Australia/U.K.)

Hardware

AXON body USB Cable

AXON body Camera

AXON body Wall Charger

Quick Reference

Audio quality will be reduced if the camera is not in the holster.

Bluetooth Pairing and Upload

Status LED

Bottom View

Volume/Pairing

Battery Status Button

Push to Show Status of

Battery

Camera Lens

Speaker

Battery LED

Green = 41% - 100%

Yellow = 20% - 40%

Red = Less Than 20%

Microphone

Power Switch

Red = On/Buffering

Event Button

Double Tap = Start Record

Hold 3 Sec = Stop Record

Recharging/Dataport

Data Transfer & Recharging

through PC or EVIDENCE.com

Dock

Top View

Operation LED

Step 1:

Recording

The AXON body camera has two operating modes. The default mode, or BUFFERING
mode, provides pre-event buffering to capture activities that occur before you
activate the EVENT (recording) mode.

1

Turn the system on. Move the ON/OFF switch to the ON position.

Solid Red

Boot Up Mode

Blinking Green

Buffering Mode

• The camera takes a few seconds to boot up and be ready to record (the red area

under the switch will be exposed with the switch moved to the ON position).

• The operation LED will be solid red and then transition to blinking green

when the system goes into BUFFERING mode.

• The AXON body camera will go into BUFFERING mode after the boot up

sequence. The BUFFERING mode holds the previous 30 seconds of video
[NO AUDIO] leading up to the beginning of a recording.

2

To record, quickly double-press the EVENT button.

• The camera now records audio as well as video.

• The camera will beep twice to let you know that recording has started. The

2 beeps will repeat every 2 minutes (if the system is muted, there will be
no audio notifications).

• The operation LED will blink red.

Event Button

Blinking Red - Record Mode

3

To stop recording and return to BUFFERING mode, press and hold the EVENT

button for at least 3 seconds until there is a long, audible beep.

Because the system does not capture audio in BUFFERING mode, the first 30
seconds of a recorded event will be video-only (depending on your agency’s
settings). BUFFERING mode starts only after the camera is turned on. The system
does not record when the AXON body camera is turned off.

Advertising