Taser Axon-Flex - Manual

Step 2:
Controller Operation LED
The controller’s operation LED displays the system’s current operating mode.
Operating Mode Controller LED
Recording Blinking red
Buffering Blinking green
Booting up/powering down Solid red
Disconnect Blinking yellow
Step 3:
Controller Battery LED
The controller’s battery LED displays the battery’s remaining capacity, when the
device is being used or when charging.
Battery Capacity Battery LED
Battery capacity is 41-100 percent Green
Battery capacity is 20 - 40 percent Yellow
Battery capacity is less than 20 percent
Red during operation; flashing red and
yellow during charging
Battery critically low Blinking red and yellow
TASER AXON flex Quick Start Guide
English (U.S./Canada/Australia/U.K.)
Hardware
AXON flex Camera
AXON flex Controller
Straight or Coiled Cable
with Right-Angle Connector
Quick Reference
Volume/Pairing Button
Operation LED (On Back)
Power Switch
Red = On/Buffering
Event Button
Double Tap = Start Record
Hold 3 Sec = Stop Record Battery LED
Green = 41% - 100%
Yellow = 20% - 40%
Red = Less Than 20% Battery Status Button
Push to Show Status of
Battery
Step 1:
Recording
The AXON flex system has two operating modes. The default mode, or BUFFERING
mode, provides pre-event buffering to capture activities that occur before you
activate the EVENT (recording) mode.
1 Turn the system on. Move the ON/OFF switch to the ON position.
Solid Red
Boot Up Mode
Blinking Green
Buffering Mode
• The camera takes a few seconds to boot up and be ready to record (the red area
under the switch will be exposed with the switch moved to the ON position).
• The operation LED will be solid red and then transition to blinking green
when the system goes into BUFFERING mode.
• The system will go into BUFFERING mode after the boot up sequence. The
BUFFERING mode holds the previous 30 seconds of video [NO AUDIO] leading
up to the beginning of a recording.
2 To record, quickly double-press the EVENT button.
• The system now records audio as well as video.
• The system will beep twice to let you know that recording started. The 2
beeps will repeat every 2 minutes (if the system is muted, there will be no
audio notifications).
• The operation LED will blink red.
Event Button Blinking Red - Record Mode
3 To stop recording and return to BUFFERING mode, press and hold the EVENT
button for at least 3 seconds until there is a long, audible beep.
Because the system does not capture audio in BUFFERING mode, the first 30
seconds of a recorded event will be video-only (depending on your agency’s
settings). BUFFERING mode starts only after the camera is turned on. The system
does not record when the AXON flex controller is turned off.
AXON flex