Tube Tech PE 1C Program Equalizer - Manual

LYDKRAFT ApS
Mose Allé 20, DK2610 Rødovre
Denmark
1
TUBE-TECH PE 1C
program equalizer
DESCRIPTION
The TUBE-TECH program equalizer PE 1C contains a passive filter and a tube (valve)
based amplifier to restore the loss from the filter.
The filter has a low frequency boost/attenuate section with 4 selective frequencies, a high
frequency boost section with a variable bandwidth and 10 selective frequencies and a high
frequency attenuation section with 3 selective frequencies.
The filter is placed directly after the input transformer therefore eliminating noise from the
amplifier when boosting either low- or high frequencies.
The amplifier consists of two tubes (valves) in push-pull configuration (one ECC 83 as the
pre-amp and phase splitter, and one ECC 82 as the output stage), and an output
transformer.
Both input and output are balanced and fully floating.
The in/out key switches the filter in and out without clicks and changes in level, while the
amplifier remain in the signal path.
The power supply for the pre-amp and phase splitter are stabilized and the heaters of both
tubes (valves) are fed with a stabilized DC voltage.
The whole amplifier (including input and output transformer) and the power supplies are
placed on one PC-board.
(030507)