UVP 81-0203-01 3UV Lamps User Manual

3uv series handheld lamps operating instructions

Advertising
background image

Wavelength Selector Knob

Filter Frame Securing Screws

3UV Series Handheld Lamps

Operating Instructions

Introduction


The 3UV Series of Handheld Lamps offers a uniform and intense source of ultraviolet light (radiation) with three
UV tubes housed in one lamp. The lamps emit one of three UV wavelengths (254nm, 302nm or 365nm UV) in
four, six and eight watt configurations for exposure or illumination of materials. All 3UV Series Handheld Lamps
are lightweight with a rugged housing. Each lamp features a uniquely designed reflector surface mounted
behind each tube to provide maximum UV fluorescence.


Important Safety Information


Caution: Shortwave and midrange UV radiation will cause damage to unprotected eyes and skin. Before
operating any unit, be sure all personnel in the area are properly protected. UV Blocking Eyewear should be
worn as well. UVP has a complete line of UV Blocking Eyewear: Spectacles, Goggles and Faceshield designed
for this purpose.


Operation


Plug the power cord into a properly grounded electrical outlet. The
proper voltage of the lamp is found on the product information label. A
selector knob is conveniently located on top of the unit to select the
appropriate UV source. Each lamp comes with one UV tube of each UV
wavelength: 254nm, 302nm and 365nm UV.


Specifications


Physical dimensions for four, six and eight watt lamps:

Model

Dimensions

3UV-34 (four watt)

9.5”L x 3”W x 4.5”D (241 x 76 x 114 mm)

3UV-36 (six watt)

12.5”L x 3”W x 4.5”D (318 x 76 x 114 mm)

3UV-38 (eight watt)

15.5”L x 3”W x 4.5”D (394 x 76 x 114 mm)


Maintenance, Repair and Technical Assistance


Replacement parts for the 3UV Handheld Lamps and accessories are shown here. For all other replacement
parts, contact UVP’s offices or your authorized distributor.

Replacing the Tubes

Always disconnect the lamp from the electrical
power source prior to replacing tubes.

1. Remove the filter frame by unscrewing the

two Phillips head screws securing the frame
to the body then sliding the frame off. This
exposes the rotating lamp assembly.

81-0203-01 Rev D

Advertising