Appendix d: regulatory information, Fcc statement, Fcc radiation exposure statement – Linksys WRT160N User Manual

Page 34: Safety notices, Industry canada statement, Regulatory information, Industry canada radiation exposure statement

Advertising
background image

Appendix D

Regulatory Information

33

Wireless-N Broadband Router

Appendix D:

Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.
This product has been tested and complies with the

specifications for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in

a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not

installed and used according to the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which is found by turning the equipment off and on, the

user is encouraged to try to correct the interference by

one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or

devices
Connect the equipment to an outlet other than the

receiver’s
Consult a dealer or an experienced radio/TV technician

for assistance

FCC Caution: Any changes or modifications not expressly

approved by the party responsible for compliance could

void the user’s authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. This

equipment should be installed and operated with

minimum distance 20cm between the radiator and your

body.
This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter. IEEE

802.11b or 802.11g operation of this product in the USA is

firmware-limited to channels 1 through 11.

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG

or larger telecommunication line cord.
Do not use this product near water, for example, in a

wet basement or near a swimming pool.
Avoid using this product during an electrical storm.

There may be a remote risk of electric shock from

lightning.

WARNING:

This product contains lead, known

to the State of California to cause cancer, and

birth defects or other reproductive harm. Wash

hands after handling.

Industry Canada Statement

This Class B digital apparatus complies with Canadian

ICES-003 and RSS210.
Operation is subject to the following two conditions:

This device may not cause interference and

1.

This device must accept any interference, including

2.

interference that may cause undesired operation of the

device. This device has been designed to operate with

an antenna having a maximum gain of 1.5 dBi. Antenna

having a higher gain is strictly prohibited per regulations

of Industry Canada. The required antenna impedance

is 50 ohms.

To reduce potential radio interference to other users,

the antenna type and its gain should be so chosen

that the EIRP is not more than required for successful

communication.

Industry Canada Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits

set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance

20cm between the radiator & your body.
This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

Advertising