Open blue parts bag, Caution, Shaft on top of power head (fig.1-2) – Genie Pro max PMX-IC B Series User Manual

Page 10: Fasten channel to power head, Do not, Attach emergency release tag (fig. 1-1), Shaft on top of power head (fig. 1-3)

Advertising
background image

Fig. 1-3

No. 10-24 x 1/2

Hex Head Screws

5/16

x 1/2

Hex Head Screws

D

-Shaft and Hole

3. Place power head and channel on clean,flat surface.

4. Slide drive end of channel down over

D

-shaft on top of

power head (Fig.1-2).

Support header end of channel level with power head.

Slide carriage to align

D

-shaft with

D

-hole in sprocket.

Slide channel down

D

-shaft flush with power head.

5. Fasten channel to power head .

Align mounting holes in front and rear of power head frame.

Insert and securely tighten the four (4) No.10 x 1/2

hex

head screws [69].

NOOTTEE:: CChain iinnnnerr-sslidee oor bbeelltt buullett sshoouuld rremmaainn at

mid--traavel when aasssemblingg to power hheeaad to providee ppropeer

trraveel whhenn setttiinng lliimmiitts.

1. Attach emergency release knob cord (Fig. 1-1).

Tie overhand knot in end of cord.

Thread cord through knob so knot is inside knob.

Thread cord through hole in carriage lever.

Tie overhand knot in other end of cord.

Do Not

cut cord until after power head is mounted.

2. Attach emergency release tag (Fig. 1-1).

Thread wire through hole in carriage lever.

Wrap wire around itself, tie securely.

PLEASE NOTE THE ASSEMBLY PROCEDURES

ARE DIFFERENT FOR RAIL AND CHANNEL. BE

SURE TO FOLLOW THE APPLICABLE STEPS.

Fig. 1-2

Fig. 1-1

Do Not

attempt to run power head or to set limits until

operator is fully assembled and attached to the door.

D

-Shaft and Hole

Hex Head Screws

Carriage Stop

CAUTION

Do Not

attempt to run power head or to set limits until

operator is fully assembled and attached to the door.

Toward Door

Toward Power Head

Carriage

No. 10 x 1/2

Hex Head Screw

5/16

x 1/2

Hex Head Washer Screw

Emergency

Release

Tag

Emergency

Release

Cord

Emergency

Release

Knob

Sprocket Saddle

11

...........

OOOPPEERRRRAAAATTTOOORR AAAASSSSSSEEMMMMBBLLYYY

FFOOR HELP--1.800..3554.364433 OOR GENIEECOOMPANY.COOM

10

CCCCHHAANNNNNNEEEELL &&& PPPPOOOOWWW

WEERRR HHHHEEAADD AASSSSSSSSEEEMMBBLLLLYYY

RRAIL && PPOOWEERR HHEEAAD ASSEMBLY

3. Place power head and rail on clean, flat surface.

4. Slide drive end of rail down over

D

-shaft on top

of power head (Fig. 1-3).

Support header end of rail level with power head.

Slide carriage enough to align

D

-shaft with

D

-hole

in sprocket.

Slide rail down

D

-shaft flush with power head.

drags on the rail

CAUTION

OPEN BLUE PARTS BAG

Screws for attaching light cover are included in this

bag. Please set aside for use later.

[69]

[112]

[69]

[69]

[112]

Advertising
This manual is related to the following products: