Toreduce the risk of severe injury or death, Important installation instructions, Safe-t-beam – Genie Pro max PMX-IC B Series User Manual

Page 4: Stb) non-contact reversing system, Safe-t-reverse, Contact reversing system, Safe-t-stop, Timed reversed system, Force guard, Control

Advertising
background image

4

Garage doors are large, heavy objects that move with the help of springs

under high tension and electric motors. Since moving objects, springs under

tension, and electric motors can cause injuries, your safety and the safety of

others depend on you reading the information in this manual. If you have

questions or do not understand the information presented, call your nearest

service representative

In this section and those that follow, the words

Danger,Warning,

and

Caution

are used to emphasize important safety information.

The word:

DANGER

means that severe injury or death will result from failure

to follow instructions.

WARNING

means that severe injury or death can result from failure

to follow instructions.

CAUTION

means that property damage or injury can result from failure

to follow instruction.

The word

NOTE

is used to indicate important steps to be followed

or important considerations.

OVERVIEW OF

POTENTIAL HAZARDS

POTENTIAL

HAZARD

EFFECT

PREVENTION

Keep people clear of opening while door is

moving.

Do Not

allow children to play with the door

operator.

Do Not

operate a door that jams or one that

has a broken spring.

MOVING

DOOR

WARNING:

Can Cause

Serious Injury

or Death

Turn off power before removing operator cover.

When replacing cover, make sure wires are not

pinched or near moving parts.

Operator must be properly grounded.

ELECTRICAL

SHOCK

WARNING:

Can Cause

Serious Injury

or Death

Do Not

try to remove, repair or adjust springs

or anything to which door spring parts are

fastened, such as, wood blocks, steel

brackets, cables or other like items.

Repairs and adjustments must be made by a

trained service person using proper tools and

instructions.

HIGH

SPRING

TENSION

WARNING:

Can Cause

Serious Injury

or Death

Safe-T-Beam

®

(STB) Non-Contact Reversing System

Places an invisible beam across door opening that reverses the door during down travel to the fully open

position if anything passes through beam

Safe-T-Reverse

®

Contact Reversing System

Automatically stops and reverses a closing door within 2 seconds of contact with an object

Safe-T-Stop

®

Timed Reversed System

Automatically opens a closing door if door does not close within 30 seconds

Force Guard

®

Control

Used to set the force required for opening and closing door For maximum safety set the minimum force

required to fully open and close door

Automatic Lighting System

One or two light bulbs (depending on model) up to 100 Watts max each are used for safer entries and exits

The light turns on when door is activated and automatically turns off 4 5 minutes later

Manual Emergency Release

Allows the garage door to be opened or closed manually for emergencies or maintenance

IMPORTANT

INSTALLATION

INSTRUCTIONS

1. READ AND FOLLOW ALL SAFETY, INSTALLATION AND

OPERATION INSTRUCTIONS. If you have any questions or
do not understand an instruction, call your service
representative.

2. Do Not install operator on an improperly balanced door. An

improperly balanced door could cause severe injury. Repairs
and adjustments to cables, spring assembly, and other
hardware must be made by a trained service person using
proper tools and instructions.

3. Remove all ropes and disable all locks connected to the

door before installing operator.

4. Install door operator 7 feet or more above the floor. Mount

the emergency release knob 6 feet above the floor.

5. Do Not connect the operator to the source of power until

instructed to do so.

6. Locate the control button:

• Within sight of door.
• At a minimum height of 5 feet, so small children cannot

reach it.

• Away from all moving parts of the door.

7. Install the entrapment WARNING label next to the wall

button or console. Install the emergency release tag on, or
next to, the emergency release

8. The operator must reverse when the door contacts a 1-1/2

inch high object on the floor at the center of the doorway.
This is about the size of a 2” x 4” board laid flat.

Toreduce the risk of

severe injury or death:

W

WAAAARRNNNNIINNNGGGG

::

SAAFETTYY INNFORRMAATIOONN

OPERRATOR IINNSTTAALLLLAATTIION

SSAAAFFEETTYY FFEEAATTTTUUURRREESS

((((vvvvaaaarrrriieess bbyy mmooddddeell))

Advertising
This manual is related to the following products: