Fluke 189 - Manual (Page 71)

5-1
Chapter 5
Changing the Default Settings
Introduction
The meter allows you to change the default operating
configuration of the meter by changing setup options
made at the factory.
Many of these setup options affect general meter
operations and are active in all functions. Others are
limited to one function or group of functions.
These settings are stored and can be changed in the
Setup mode using the procedure described in this
chapter.
Selecting Setup Options
To enter the Setup mode, turn the meter on and press
O T
(SETUP).
In the Setup mode, each press of
O T
(SETUP)
saves changes to the last selection and steps to the next
option.
Each setup option appears in the primary display in the
sequence shown in Tables 5-1 and 5-2.
The options in Table 5-1 are available only when the
preconditions are met. The options in Table 5-2 are
available for all functions. (When measuring dc volts, none
of the preconditions in Table 5-1 are required, and only
the selections shown in Table 5-2 will appear.)
To exit the Setup mode, Press O N (CANCEL).
Be sure to save your last selection by pressing O T
first.)