Uniden BCD396XT - Manual (Page 128)

Friday, November 07, 2008 128
System Select in Scan Hold Mode
When you go to Quick Select System from Scan Hold Mode and exit from this state, the scanner holds on
the first channel of the selected system.
If you select a locked out system, the locked state for the selected system is not changed.
Quick Save for CTCSS/DCS/P25 NAC Data
When CTCSS/DCS search or P25 NAC search is set for a conventional channel and the scanner is detecting a
CTCSS/DCS tone data or P25 NAC data, you can store the tone data into the current channel by pressing [E
/ yes / gps]. The scanner prompts "Set Found CTCSS/DCS?" and "Yes="E" / No="."".
Set Found
CTCSS/DCS?
Yes=
”E” / No=”. ”
Press [E / yes / gps] to store the tone data and go to the editing menu for the current channel.
Press [. / no / pri] to go to the editing menu for the current channel without storing it.
Press [Scan / srch] or [Hold / ] to go to Scan Mode or Scan Hold Mode without storing it.
Press [L/O] or [MENU] to cancel the prompt and returns to the previous mode.
Set Found
P25 NAC?
Yes=
”E” / No=”. ”