Uniden BCD396XT - Manual (Page 130)

Friday, November 07, 2008 130
F+[Scan / srch] key
If the current system is a conventional system or search range:
・ Press this key to display the prompt for starting Quick Search.
・ Press [E / yes / gps] to start Quick Search.
・ Press [. / no / pri] to go to Search for....
・ Press [L/O] to cancel the prompt.
・ Press [Hold /
] to go to Quick Search Hold Mode for the current frequency.
If the current system is a trunked system:
・ Press this key to switch between ID Search and ID Scan.
F+[Hold / ] key
Press this key to toggle Close Call functions.
Long press this key to start Close Call Only Mode.
F+[L/O] key
Press this key once to temporarily lock out a system, site, or a search range. When the scanner is turned
off, this is unlocked.
Press this key twice in a second to lockout a system, site or a search range. When the scanner is turned off,
these lockouts remain.
Long press this key to display the prompt “Unlock All Systems?” to unlock all systems, sites, search ranges
and Close Call Hits system and enable all Quick Keys for all systems/sites.
Press [E / yes / gps] to unlock all data.
Press [. / no / pri] to return to the previous mode without unlocking.
F+[1 – 9, 0] key
Press this key to enable or disable GQKs for the current system.
F+[. / no / pri] key
Press this key to toggle Priority Mode for conventional priority.
F+[E / yes / gps] key
Press this key to change to the GPS Mode.
Long press this key to store the current location. Then the scanner prompts you to select the location type.
F+[MENU] key
Press this key to go to the editing menu for the current system or current search range.
If the current system is a protected system, the scanner displays the “Protected System Access Not
Allowed Press Any Key”
and sounds an error tone.